Case 580SR Service Manual page 546

www.maskinisten.net
54
Take the piston out (14).
If necessary, blow in air through the brake bleeder
vent to eject the piston, using the minimum pres-
sure.
Remove the O-rings (16) and (17) from the piston
(14) and check their conditions.
Assembly
Assemble the O-rings (16) and (17) on the piston
(14) and lubricate the fraying surface piston/flange
with a light layer of grease.
Install the piston (14) into the brake flange (7) and
then a support flat disk on the piston and with a lever
anchored to an eyescrew, exert a pressure just
enough to insert the piston (14) into the brake flange
(7).
Collect the self-adjust kits components and insert
them in the piston (14).
Insert the fastening screws (11) and tighten them to
the specified torque.
SECTION 27 - REAR AXLE
Copyright ©
16 17 14
F28040
16 17 14
F28040
14
7
F28042
14
11
F28116