Case 580SR Service Manual page 452

www.maskinisten.net
100
Remove the wheel hub (11) using levers and a ham-
mer to facilitate the operation.
NOTE: collect the bearing cone (9).
Position the wheel hub (11) on a flat surface and re-
move the seal ring (13) with a lever.
NOTE: destructive operation for the seal ring (13).
Remove the bearing cups (9) and (12) using a ham-
mer and a suitable drift.
Remove the bearing cone (12) from the swivel hous-
ing end using a suitable extractor.
Unscrew and remove the fastening bolts (19) and
(17) from the upper (18) and lower (16) king pin.
S
WARNING
Before removing the king pins (16) and (18), secure
the swivel housing (14) to a rope or a hoist or to any
other supporting device; observe all current safety
regulations to guarantee the operator's safety.
Remove the king pins (16) and (18).
Extract the swivel housing (14) from the axle shaft
and the cardan shaft.
SECTION 25 - FRONT AXLES
13
12
11
10
9
17 19
16
Copyright ©
15
11
9
F27254
F27412
18
14
F27256
14
F27257