Case 580SR Service Manual page 938

www.maskinisten.net
110
3.6 SIDE INSTRUMENT CLUSTER (580SR+ / 590SR / 695SR)
1. CAUTION MASTER LAMP
This lamp signals a not critical caution.
When this caution is active, it is necessary to
change the operating mode, plan a down time to
carry out maintenance or, if the fault continues,
consult your dealer.
This warning lamp turns on at the same time of
lamps (5), (9), (11), (13), (14) and (16) that indi-
cates a fault on the machine.
2. SIDE LIGHT AND LOW BEAM INDICATOR
LAMP
This indicator lamp turns on when the side lights
or the low beams are on.
3. MAIN BEAM INDICATOR LAMP
This indicator lamp turns on when the main
beams are on.
4. DIRECTION INDICATOR LAMP
This lamp turns on when the direction indicators
are working.
5. BRAKE LIQUID LEVEL WARNING LAMP
This lamp turns on and the audible warning de-
vice sounds when the brake liquid is at minimum
level.
SECTION 55 - ELECTRICAL SYSTEM
6. "FOUR WHEEL STEER" (4WS) STEER INDI-
CATOR LAMP
This lamp turns on when 4 wheel steer mode is
selected and phased.
7. "ROAD" (4WS) STEER INDICATOR LAMP
This lamp turns on when 2 wheel steer mode is
selected and phased.
8. "CRAB" (4WS) STEER INDICATOR LAMP
This lamp turns on when crab steer mode is se-
lected and phased.
NOTE: if the three lamps turn on at once, this
means there is a problem with the electrical circuit.
Consult your Dealer.
9. ENGINE OIL PRESSURE WARNING LAMP
This warning lamp turns on and the audible
warning device sounds when the engine oil
pressure is too low. If the lamp turns on while the
machine is working, move the machine to a safe
place, immediately stop the engine, remove the
starter switch key and find the cause of the prob-
lem.
Copyright ©
6