Case 580SR Service Manual page 944

www.maskinisten.net
116
4.3 PROCEDURE ABOUT SELF TEST
Z
Any of the above at with ignition
low
Normal "Key ON"
Z
Any of the above at "Key ON"
Step 1: Lamps switch on at full intensity.
Step 2: Lamps switch off after 2 seconds.
Step 3: Wait 2 seconds.
Step 4: Instrument backlighting turns on at full intensity.
Step 5: Lamps switch off after 2 seconds.
Step 6: Wait 2 seconds.
Step 7: Sweep all 5 gauges to maximum angle.
Step 8: 2 seconds after maximum angle sweep to red
border.
Step 9: 2 seconds after red-green border is reached move
to second red border for voltage.
Step 10: Park all gauges and start LCD test.
Step 11: When LCD test is complete sound alarm for 2
seconds.
Step 12: The following is shown on the LCD display until the key is turned to OFF or the
cycle ends. All gauges and lamps should work as normal and engine will be able to be
started.
SECTION 55 - ELECTRICAL SYSTEM
Power up LCD and show work
Initiate Self test
100 mA < Current draw < 1amp
10 mA < Current draw < 1 mA
100 mA < Current draw < 1 A
10 mA < Current draw < 100 mA
Makes sure that needles can
move freely and have proper po-
Makes sure that needles are
properly calibrated to applique
hours for 10 seconds
Go to menu
Z
Check:
Check:
sition
Copyright ©
Foot max: X.X.
Foot min: X.X.
113/111
range
Hand max: X.X. 125/120
Hand min: X.X. range
113/122
Foot %: XXX
Hand %: XXX
range
Requested en- 98/88
gine rpm: XXX range
Fuel lvl: XX.X 117/120
Fuel tank: XX range
Voltage: XX.X
116/124
Trans oil temp:
range
XX
Brakes: XXX
102/92
Engine rpm:
range
XXXX
Radiator water
107/123
temp. XXX
range
Air temp. XXX
Engine oil temp:
122/126
XXX
range
Fuel temp: XXX
$