Case 580SR Service Manual page 399

www.maskinisten.net
Remove the wheel hub (11) using levers and a ham-
mer to facilitate the operation.
NOTE: collect the bearing (9).
Position the wheel hub (11) on a flat surface and re-
move the seal ring (13) with a lever.
NOTE: destructive operation for the seal ring (13).
Remove the bearing cups (9) and (12) using a ham-
mer and a suitable drift.
Remove the bearing (12) from the swivel housing
end using a suitable extractor.
Unscrew and remove the fastening bolts (19) and
(17) from the upper (18) and lower (16) king pin.
S WARNING
Before removing the king pins (16) and (18), secure
the swivel housing (14) to a rope or a hoist or to any
other supporting device; observe all current safety
regulations to guarantee the operator's safety.
Remove the king pins (16) and (18).
Extract the swivel housing (14) from the axle shaft
and the cardan shaft.
SECTION 25 - FRONT AXLES
5
7
17 19
16
Copyright ©
47
15
11
9
F27254
9
8
F27255
18
14
F27256
14
F27257