Case 580SR Service Manual page 464

www.maskinisten.net
112
Once all the adjustment operations have been com-
pleted, fit the ring nut retainers (8) and their screws
(9), tightening them to the requested torque.
Tighten the screws (12) of both half collars (11) to
the specified torque.
Before matching surfaces, make sure that they are
perfectly clean, degrease and clean them with ap-
propriate detergents.
Spread a film of adhesive on the contact surface be-
tween the axle beam (14) and the differential carrier
(1).
NOTE: check that the two pins (13) are in their
housing.
Position the differential support (1) on the axle hous-
ing (14), and tighten the retaining screws (2) to the
requested torque.
SECTION 25 - FRONT AXLES
2
13
1
Copyright ©
9
8
F27298
12
11
F27434
14
F27435
14
F27501