Case 580SR Service Manual page 156

Hide thumbs Also See for 580SR:
Table of Contents

Advertisement

www.maskinisten.net
90
1.12 FAULT FINDING
PROBLEM
Transmission fails to drive in
either direction
Transmission drives in one
direction only
Delay in taking up drive
No drive from 4WD
Transmission overheating
Operating in too high of gear
range for conditions
Difficult gear selection
Vehicle moves with direction
valve in neutral position
High stall speed
Low stall speed
SECTION 21 - TRANSMISSION
Low or no pump pressure.
Low or no oil in transmission.
Mechanical failure in transmission.
Worn or broken input shaft seal rings.
Pressure relief solenoid valve faulty.
Direction control solenoid valve inoperative.
Blockage of restricted flow in oil ports.
Low oil pressure on one clutch pack due to leaks.
Clutch piston seals worn or damaged.
Clutch pack excessively worn.
Direction control solenoid valve or coil faulty.
Mechanical failure in transmission.
Blockage of restricted flow in oil ports.
Worn or broken input shaft seal ring.
Low converter pressure.
Low oil level.
Low clutch pressure.
Faulty modulation in direction control solenoid valve.
Blocked direction control solenoid valve.
Blockage of restricted flow in oil ports.
4WD solenoid valve or coil not operating.
Mechanical failure in transmission.
Low 4WD clutch pack pressure.
Worn 4WD clutch pack.
Oil level too high or low.
Cooler flow restricted.
Low oil pressure.
Clutch packs slipping due to low pressure or wear.
Mechanical failure in transmission.
Excessive stall operation.
Shift to lower gear.
Forward or reverse travel clutch pack pressurised when not selected.
Direction control solenoid valve faulty.
Input shaft seal rings leaking.
Mechanical failure in transmission.
Forward or reverse travel clutch pack not releasing due to a mechanical
failure.
See "Difficult gear selection".
Low oil level. Air in oil.
Clutch plates slipping due to low pressure or wear.
Torque converter faulty.
Converter relief valve faulty.
Wrong torque converter installed.
Poor engine performance.
Torque converter faulty.
Wrong torque converter installed.
CAUSE
Copyright ©

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

580sr+590sr695sr

Table of Contents