FAG Detector III User Manual page 70

you can perform the measurement at this measuring point.
You can only select the statuses that are accessib le as a follow-up
status of the current status.
Further information in the chapter "Automatic assignment of RFID tags to
measuring points
Balancing settings
Type of vibration unit: Select Acceleration, Velocity or Displacement.
Peak setting: Specify here whether the peak-to-peak value, the peak value or
the root mean square (RMS) should be evaluated.
Balancing OK at: define the limit value for the balancing measurement here. If
all measured values are below the value specified during the trim run
balancing procedure has been successfully completed and the Detector ends
the balancing measurement.
Rotor weight: Here you enter the weight of the rotor (kg) for which the balancing
measurement is performed. The Detector uses this value to calculate a
suggested test weight (see notes in section "Balancing measurement"
you enter 0 here, the Detector cannot calculate a suggested test weight.
Measurement averaging count: The Detector averages measured values
during the measurement. Specify how many values are to be used for
averaging.
Rotational speed settings
Enter the Nominal rotational speed (in the predefined unit, see "Program
settings / General
boxes. Note that a deviation of more than 10% is not possible. If the acquired
speed by the Detector is outside the rotational speed range defined here, the
Detector displays an error message
The Detector averages the rotational speed values during the measuring
process. Specify how many rotational speed values are to be used for
averaging at Turning speed averaging count. If you enter 20, for example, the
Detector averages the values obtained for rotational speed across 20
revolutions.
Balancing plane settings
Number of balancing planes: Select "1" for single-plane balancing or "2" for
two-plane balancing.
Enter a plane name for the selected planes or use the names suggested by
the Trendline software (see also "Program settings / General
70
".
54
") and the Max. allowed deviation in the appropriate input
146
.
263
the
245
). If
234
"). Due to the
146