Trendline 3; Program Installation; System Requirements - FAG Detector III User Manual

4 Trendline 3

The Trendline software is the server-based program for the Detector III. The
Detector itself is designed only for the recording of measured values. All data
organization and evaluation tasks are carried out by the Trendline software.
The software is configured to monitor a system as well as evaluates, analyses,
and stores the measured data collected by the Detector.
Further, Trendline 3 manages the exchange of data between the server on which
the software is running and the Detector.

4.1 Program installation

This chapter describes the installation of the Trendline software.
The Trendline software requires the MS SQL database server. It must be installed
either on the local computer or on a network server. If you are already using an
MS SQL database server (see "System requirements"
CM databases with this.

4.1.1 System requirements

In order to use the Trendline software in an optimum way, the following minimum
requirements must be met:
General system requirements
Pentium III PC with 500 MHz (recommended: 1 GHz)
At least 512 MB RAM (recommended: 1 GB; Windows 7: 64 Bit version)
Screen resolution: 1024x768 (pixels)
Operating systems
Trendline software 3.6: Windows XP SP3, Windows 7: 64 Bit version
Database program MS SQL Express 2005: at least Windows XP SP3 or
Windows 7: 64 Bit version
MS Windows Server operating systems are not supported.
22
The Trendline software version 3.6 operates only with
the Detector firmware 3.6.
If your Detector has a lower firmware version, please
update the Detector's firmware .
267
), you can register the
22