Create Reports; Measurement Report - FAG Detector III User Manual

want to send. If you have unchecked the Time range checkbox, all previous data
will be sent.
Enter at Data to be exported, which data shall be transferred. If no data can be
sent via this selection anymore, i.e. if you want to send alarms only, but no alarms
are in the selection, the OK button will be disabled.
Now click on OK to send the data. Depending on your e-mail settings the data
are transferred immediately or they are copied into an Outlook mail, which you
will have to send manually.

4.14 Create reports

The Trendline software offers the following report types:
The measurement report
measured values for the sensors defined in the configuration in tabular and
graphic form.
You can use the alarm report
alarms accumulated to date for freely selectable elements
configuration.
The route report
measurement signals for a given route in the form of check lists. You can
systematically and reliably "work through" the measuring point of a route with
the aid of the route report.
The balancing report
measurements carried out for one element of your configuration.
The run up/coast down report
configuration settings and the associated amplitude/phase diagrams.
The amplitude/phase report
configuration settings and the associated amplitude/phase diagrams.
Also see report options

4.14.1 Measurement report

To create a measurement report click on Measurement report in the Service
menu. The Configure report window opens.
127 provides a comprehensive overview of the
to create an overview of pre-alarms and main
132
presents all measuring points and corresponding
133
provides you with a clear overview of balancing
133
135 creates an overview of the run up/coast down
creates an overview of the amplitude/phase
134
149
.
Trendline 3
in your
127