FAG Detector III User Manual page 254

Show previous measurements
In order to view the results for free measurements previously carried out select
directly after the measurement Previous data and select the desired
measurement from the list.
Multiple measurements
You can repeat a free CM measurement just like a CM measurement. For more
information on multiple measurements, see the section Multiple measurements
.
231
Free balancing measurement
Position the sensor(s) at the desired measuring point.
Select Balancing > New measuring point.
Then go to Select template to choose a suitable template. You can select the
template of a previous measurement, alternatively.
In the next menu you can change the template name so that the free
measurement can later be assigned to the measuring point at which it was
recorded.
o If you accept the name without changing it, the free measurement is assigned
the template name and also a reference number that increases by one each
time a new measurement is taken using this template (<Name> 1, <Name> 2,
...).
o To change the name select Change name and confirm your choice with the
Enter button . On the next screen, the name of the template selected and the
current order number are displayed, and a cursor is positioned under the first
letter. Change the name as described in Key pad entries
After changing the name select Continue.
Select Settings to adopt the configuration of the template.
254
.
213