FAG Detector III User Manual page 220

Condition monitoring
Measurements are performed using the Condition Monitoring menu and its
submenus. Here you can decide whether you want to perform a pre-configured or
free measurement as well as which measuring points should be used to record
data. After selecting desired the measuring point, you can begin the
measurement and then decide if you want to save or discard the data. During the
measurement operation, the measured results and system messages are
shown on the display. You can find a more detailed description in "Measuring
procedure ".
222
Balancing
You can use this option to select the measuring point for the balancing
measurement .
234
Run up/coast down
Use this menu item to select the run up/coast down for determining resonant
ranges 247 .
Amplitude/phase
Use this menu item to select the amplitude/phase measurement .
249
Single measurements
Use this menu item to do single measurements 258 .
System menu
From the system menu you can specify global settings for the Detector.
Change language
Select display language. You can currently choose from the following languages:
German, English, French, Italian, Dutch, Spanish, Portuguese, Swedish, Finnish,
Slovenian and Turkish.
Set backlight delay
In order to save battery running time the display lighting switches off automatically
once the time preset here has elapsed. The following settings are available: 30 s,
60 s, 90 s and no automatic deactivation.
220