FAG Detector III User Manual page 63

click Do not add bearing(s) to any measurement of this measuring point.
If you want to apply the bearing information to all saved measurements, click
Add bearing(s) to all existing measurements of this measuring point.
To apply the bearing information to measurements in a certain time range,
click Add this bearing to all measurements of following time range and
select the time range.
In the Bearing configuration section enter the speed correction factor (SPF)
and select whether the bearing has a fixed outer race.
Click on .
OK
Delete selected bearing
Click on the bearing to delete and
then click .
Select from which measurements the bearing should be removed:
To keep the bearing information for the existing measurements of this
measuring point, click Do not deactivate bearing for any measurement of
this measuring point.
To delete the bearing information from all saved measurements of this
measuring point, click Deactivate bearing for all existing measurements of
this measuring point.
To delete the bearing information from measurements in a certain time
Trendline 3
63