FAG Detector III User Manual page 268

2. Select the interface connected to the Detector.
The "Installing USB serial adapter
determine the interface numb er of the USB serial adapter.
3. Select the downloaded firmware file ("Detector_3_x_x.dup"). If you downloaded
the firmware from the web page, you must also unpack the zip archive. The
FlashUpdater displays information on the changes made since the previous
release.
4. Prepare the Detector
a) Switch off the Detector.
b) Insert a thin object (a bent open paper clip, for example) into the small
opening on the left-hand side of the Detector, and hold it in this position until
it encounters resistance.
c) Switch the Detector on and hold down the power-on button. Wait for three
seconds before removing the paper clip. Now release the power-on button.
5. The new firmware is now transferred to the Detector. This may take several
minutes depending on the speed of the interface.
You can ab ort the update as long as the firmware upload has not
b egun. Click Cancel to ab ort.
268
49 " section explains how to