Data Transfer - FAG Detector III User Manual

During normal operation, the accumulator symbol (top left of display) indicates
the charge level.
Charging the accumulator
Only use the included charger for charging the b attery!
Note that the Detector cannot b e switched on during the charging
process.
In order to charge the accumulator
connect the included battery charger to a supply voltage outlet and
connect the Detector to the battery charger via the charge connector.
The charging process starts automatically as soon as the Detector is connected
to the battery charger and depending on the current accumulator charge level.
The temperature of the accumulator must be between 2 °C and 44 °C. Outside of
this range, the charging process is delayed until the accumulator has reached
the appropriate temperature.
The LEDs on the battery charger indicate the charge level. Please refer to the
battery charger manual for further information.
Recharge the accumulator regularly even when it is not in use so
that the Detector is always ready for use.
Because of the physical characteristics b y self discharge, a
accumulator can lose its stored energy within a time period of three
to four month. If you don't use the accumulator for a longer time
period, please do several charge/decharge procedures at times.

6.4 Data transfer

Data are exchanged in both directions between Detector and the computer on
which the Trendline software is installed. With the help of the Trendline software
measuring configurations and routes are created and administrated on the
computer, and measuring data are stored and evaluated.
On the one hand, measuring configurations
administrated on the computer are transferred to the Detector. On the other hand,
218
and routes created and