Device Menu - FAG Detector III User Manual

recorded measuring data are downloaded from the Detector to evaluate and
store them using the Trendline software.
The data transfer between Detector and PC is controlled by the Trendline
software.
Connect the serial interface of Detector (9-pin sub-D-connector at the
instrument shaft) with a free serial interface of the computer Trendline software
is installed on.
Follow the sequence as described in the Trendline software help menu.
You can interrupt the data transfer between Detector and computer at any time
by pressing the Esc key
The transfer of a new route or configuration to Detector deletes all
data stored on the instrument.

6.5 Device menu

When switching on the Detector, the main menu shows the following menu
items: Condition monitoring
Amplitude/phase
249
The menu items "Balancing" and "Amplitude/Phase" are only
availab le if the b alancing function is enab led
.
, Balancing
219
, Single measurements
, Run up/coast
220
and System menu
220
on the Detector.
50
Detector III
down ,
220
.
220
219