FAG Detector III User Manual page 228

Detector display in abbreviated form. Confirm your entry with the Enter button
If you have selected a comment, it will be shown at the end of the
measurement view.
To save the measurement press the Enter button
measurement press the Esc button
If you have set "Comment input on the Detector"
Trendline
automatically. If you selected "Enforce after each measurement"
you must select a comment to continue.
If you have already carried out a measurement at this point the Detector asks
whether the last measurement should be overwritten (also following a multiple
measurement
231
discard.
The measurement is saved.
Once the characteristic values have been saved the Detector jumps to the Select
measuring point menu item to enable you to record data at an additional
measuring point on the same machine (see "Selection of measuring point
If no further measurements need to be made to the machine, you can switch the
device off and move on to the next machine.
Display previous measurements
If measurements of a measurement point have been carried out earlier, you can
display the time signals and trends in the Detector.
Select Condition monitoring > Select position.
Select plant, machine and measurement position and
select Previous data.
Select the desired measurement from the list and
press the Enter button
The measurement view will be displayed. The heading shows date and time of
the selected measurement.
228
software, the
!) or whether the latest measurement should be saved or
.
. If you want to discard the
.
comment selection
.
in the
59
will appear
").
224