Editing / Deleting Sensors - FAG Detector III User Manual

alarm values. For more information about the classes of ISO 10816 see "ISO
10816 ".
220
Universal type
To enter a characteristic value at a selected measuring point that is not
measured by the vibration or temperature sensor, you can set up a universal
characteristic value in the Trendline software. For each configuration you can
create several universal characteristic values. On the Detector you can enter for
example the machine temperature and the ambient temperature for the analysis
in the Trendline software. With the characteristic value type Universal you can
define custom alarm values.
Universal characteristic values are displayed in the Detector
without unit. To assign later what has b een measured with this
parameter, you should entitle the characteristic value accordingly
(e.g. "Machine temp. [C]"). In the Trendline software you can edit
the name in the "General settings" tab . On the Detector you can
only change the name in the settings of free measurements.

4.4.5 Editing / deleting sensors

If you have added custom sensors
can edit or delete them.
Editing a sensor
In the Detector menu click Sensor > Edit.
Select the sensor in the Edit sensor window.
Edit the settings (see also Add sensor
To edit the sensor name, click on
Click OK.
Deleting a sensor
In the Detector menu click Sensor > Delete.
Select the sensor to delete in the Delete sensor window and click OK.
As long as a sensor is still in use, thus it is assigned to a
measurement point, you cannot delete this sensor.
in addition to the pre-defined sensors, you
45
).
45
.
Trendline 3
67