Trial Run - FAG Detector III User Manual

Press the Enter button
time.
Once you have measured all sensor positions, the results are displayed in a
table. If the measured values are OK, select the Values are OK menu item and
press the Enter button
with a measured value, you can use cursor keys
and the Enter button
At this point, you can select a comment. In the comment list, you can create a
new comment
227
measurements
comment input is shown. Confirm your settings with the Enter button
The measured values ob tained during the reference run are only
saved after you confirm b y clicking Values are OK b y pressing the
Enter button
discard the measured values and the Detector returns the
Balancing menu. Repeat the reference run if necessary.
Now you can proceed with the trial run

6.8.3 Trial run

To perform the trial run select Trial run from the balancing menu. With two-plane
balancing the Detector initially guides you through the test measurement at plane
1 then continues with plane 2. In the trial runs, apply a known weight to a known
position. With this information, the Detector determines the change between
reference run and trial run and can thus determine the influence coefficients.
These indicate how machine imbalance changes with a certain weight and are
used calculate the balancing weights.
If the change in vibration is too little because the test weights selected were too
small (see also "Important information" in "Balancing measurement"
once amplitude and phase have stabilized after a
to save the measured values. If you are not satisfied
to repeat this individual measurement.
or select an existing one (see "Managing comments for
68 "). If no comments exist in the list, the edit field for the
. In the tab le of results, click the Esc b utton
and
.
241
Detector III
to select this value
.
to
, the
234
241