Diagram Display; Cursor And Measuring Information - FAG Detector III User Manual

Tool & symbol
Revolutions cursor
(FFT, time signals)
Additional tools
In addition to the zoom and cursor tools you can use a range of further tools to
change the manner in which signals or cursors are displayed and transfer data to
other programs via the clipboard.
Tool & symbol
Positioning of
base cursor
Cursor
properties
Clipboard
Change diagram
boundaries

5.2.4 Diagram display

The diagram area shows the FFT, time signals and trend data diagrams. You can
specify the desired zoom area inside the diagrams and adjust the position of the
cursor using the mouse or keyboard.

5.2.5 Cursor and measuring information

The cursor information for the Trendline Viewer shows important values and
measurement data that vary depending on the cursor tool used. Each item of
cursor information contains either the value pairs for a measured value or
calculated characteristic values that are obtained by combining different cursors
within the diagram such as the difference cursor or RMS/AMV cursor. The cursor
158
Description
The rev olutions cursor marks the frequency that is assigned to a
specific speed w ith a line.
A cursor can only b e placed at a measuring point that
exists. If you click on a position in the diagram where no
measured value exists the cursor automatically jumps to
the nearest existing measuring point.
Description
Places the base cursor at a point in the diagram specified v ia
numeric input. The base cursor jumps to the measuring point
nearest the v alue entered.
Opens the cursor properties dialogue w indow w here y ou can
change the properties of the cursor currently used.
Copies an image of the current diagram v iew into the clipboard (
additional information
Changes the display of minimum/max imum v alues for the x - and
y -ax is (additional information
).
185
186 ).