Setting Up Configuration; Set Up System Tree - FAG Detector III User Manual

Connect the Detector to your PC and switch it on. Click on Search for new
Detector to register the new Detector on to the program.
You may give the Detector a name, which will be displayed in the default
display when switching on the instrument.
You can select the language for the Detector. Nevertheless it still can be
changed at the Detector.
You can set the time of the Detector either by entering the correct time and date
(to do this, click on the figure you want to change) or by clicking Send system
date to the Detector (that way the Detector is set to the same time and date as
your PC).
Here, you can select the baud rate of the Detector. Normally, you should select
the highest possible (57.6 kbps). In case of problems with communication (e.
g. the connection breaks down at times) you may select the lower baud rate of
38,4 kbps.
After completing all settings, click on OK to send the changes to the Detector.
Make sure that the Detector is switched on when clicking OK, because
otherwise no communication is possible.

4.4 Setting up configuration

4.4.1 Set up system tree

Each configuration is subdivided into three levels, e.g. section - machine -
measuring point.
Trendline 3
53