FAG Detector III User Manual page 123

position 2-4.
Click on Enter to start filtering or click on Reload.
Displayed measurements
Activate the check mark in front of the measurements that should be shown
additionally.
Toolbar
Click Toolbar to show/hide Viewer toolbar. For further information, please refer to
the description of the FIS Viewer in the "Toolbar" section.
Time signal, FFT signal
If a certain value on the trend diagram is marked with a small circle, this means
that there is a time signal for this measurement. You can view this time signal by
marking the value with the cursor and then clicking on Time signal/FFT. If there is
no time signal for the selected value, this symbol is grayed out and cannot be
selected.
Adjust alarm limits with the mouse
The alarm limits are displayed as colored lines in the diagram. The yellow line
represents the pre-alarm limit, the red line the main alarm limit. You can adjust
the alarm limits directly in the diagram by using the mouse. The changed values
will be set automatically to each characteristic value.
Press left on an alarm limit line.
Hold the mouse button down while
dragging the line to the new position.
The originally alarm limit will be displayed as a thin line in the diagram.
A pre-alarm limit cannot b e placed ab ove a main alarm limit.
Changes to the alarm limits are not activated till they have b een
sent with a configuration to the Detector.
Print time signal, print FFT signal
Click these buttons to include the respective signal in the trend report (cf.
"Printing").
Print
Click Print to create a trend report. The trend report combines the diagrams of the
selected measured data for printing. Each diagram is printed on a separate
Trendline 3
123