FAG Detector III User Manual page 55

If you are using RFID tags, the sensor cab le of the Detector must
b e provided with the delivered snap-on ferrite (see "Before you
start"
If you transfer a configuration with RFID settings to a Detector
without an RFID reader, it displays an error after data transfer
and ignores the RFID settings.
Affixing an RFID tag to a measuring point
You must first affix the RFID tag to the measuring point. There are two different
types of RFID tags:
The RFID tag "Key" can be affixed to the measuring point using a tape or wire tie.
The RFID tag "Dome" is designed especially for metallic foundations and can be
glued onto the measuring point. When using at temperatures above 85°C, you
should fix it into place using a screw, for example.
The RFID tag "Key" should not b e affixed to a metallic foundation!
The electromagnetic field can b e affected b y the metal and disrupt
the measurements taken at the measuring point.
Always use the RFID tag "Dome" for metallic foundations.
Assigning an RFID tag to a measuring point
Before using, you must assign the RFID tags placed on the measuring points.
You can do this immediately before a CM or balancing measurement. Select the
measuring points wither in the Trendline software or in the on-site Detector:
).
21
FIS.DETECTORIII.RFID.TAG.KEY (left) and
FIS.DETECTORIII.RFID.TAG.DOME (right)
Trendline 3
55