Free Measurement - FAG Detector III User Manual

points without having to reenter names and pitches.
Delete measuring point
Select this menu item to delete particular measured values.
The Detector displays a table containing all of the available measuring points. A
measuring point that has already been measured is indicated in the menu with
the symbol .
Select the measuring points you would like to delete and confirm the delete
process with the Enter button

6.11 Free measurement

In addition to the planned route
to carry out what are known as free measurements. For CM, balancing,
amplitude/phase measurements and run up/coast down measurements, select
the New measuring point menu item.
Example: You are in the process of taking a round of measurements. You
notice an unusual noise or unusually high temperature on a machine that
is not included in this round of measurements. You can use the New
position option to carry out an additional on-the-spot measurement.
In these situations measurement templates must be defined using the Trendline
- Software. The templates you create depend on your particular circumstances.
The procedure for creating and transferring measurement templates is described
in detail under "Create template
software on your Detector, you can select a default template on the device.
The Detector displays all velocity values during the free
measurement. These values are in the units selected in the
Trendline software for the template b eing used. In the Settings
menu you can also change almost all settings during the free
measurement.
Free CM measurement
Position the sensor at the desired measuring point.
252
.
measurements you can also use the Detector
112
". If there isn't a template from the Trendline
109