FAG Detector III User Manual page 187

diagrams of the active window are reset to the values automatically
calculated by the Viewer.
o Reset all customizations of all diagrams: The settings for all diagrams in all
Viewer windows are reset to the values automatically calculated by the
Viewer.
4. Click OK.
The diagram (and other diagrams if relevant) is displayed with the chosen
settings applied.
Or:
Click on Cancel to discard the changes.
Edit rotational speed
Use this tool to change the rotational speed information in an FFT or
time signal.
1. Click on the Edit rotational speed symbol.
The "Edit rotational speed" dialogue is displayed.
2. Click on the signal whose rotational speed you wish to change. If there are
multiple signals, you can right-click to select or deselect them all.
3. Enter the appropriate speed in the Rotational speed box and select the unit
(rpm or Hz). The rotational speed is automatically converted when you change
the unit.
4. Click Apply rotational speed to selection to allocate the new speed to the
selected signals.
5. Click Reset select to defaults to undo the change of speed.
FIS Viewer
187