FAG Detector III User Manual page 173

1. Select the difference cursor option from the cursor selection list or press the
F3 button.
The base cursor and the difference cursor are displayed in the diagram, these
are connected by a colored bar that runs along and slightly above the x-axis.
2. You can place the base cursor at any desired measuring point in the diagram
by left clicking.
3. You can position the difference cursor at any desired measuring point in the
diagram by left clicking while holding down the Shift button.
The cursor information above the diagram displays the measured values for
the base cursor and difference cursor as well as the delta value.
RMS/AMV cursor
You can calculate the effective value (root mean square) and the
arithmetic mean between two measuring points using the RMS/AMV
cursor.
To do this, place the base cursor and an additional averaging cursor at
any desired measuring point in the diagram. The distance between the
cursors is indicated by a colored bar directly above the x-axis. Both
measured values obtained with the cursors and the resulting mean
values are displayed in the cursor information.
FIS Viewer
173