General - FAG Detector III User Manual

displayed on the right-hand side of the window.
Edit program settings
Select a group.
Change settings and
click on OK.

4.16.1 General

Name
Click on Name to specify how new configurations, sections, routes, etc. should
be named when you click on New entry or New sub-entry.
Please note that b alancing plane identifiers on the Detector is
limited to four characters.
Language
Click on the Language selection box and select the dialogue language for the
Trendline software.
System of units setting
In this section you can set the units system for the measured values listed.
The following options are available:
Standard SI units,
Standard US units or
User-defined units. When making these settings you can assign units from the
range of available units to each measured variable individually.
Default values
Click on Default values to set the standards for the alarm threshold
adjustment, comment options and the time signal configuration.
If you create a new measuring point, the following values will be automatically set.
146