Telnet Access - Avaya AP-7 User Manual

Performing Advanced Configuration
Table 16 describes the HTTPS parameters.
Table 16: HTTPS Parameters
Parameter
Enable HTTPS
(Secure Web)
SSL Certificate
Passphrase
Accessing the AP through the HTTPS interface
You should use a SSL intelligent browser to access the AP through the HTTPS interface. After
configuring SSL, access the AP using https:// followed by the AP's management IP address.

Telnet Access

Table 17 describes the Telnet parameters.
Table 17: Telnet Parameters
Parameter
Telnet Interface
Bitmask
Telnet Port Number
Telnet Login Idle
Timeout (seconds)
Telnet Session Idle
Timeout (seconds)
86 Avaya Wireless AP-7 User Guide
Description
Use this drop-down box to enable SSL on the AP.
Note:
You need to reboot the AP after enabling or disabling
Note:
SSL for the changes to take effect.
Specifies the SSL Passphrase to use if Enable HTTPS has been
checked. You must change the SSL passphrase when uploading a new
certificate/private key pair, which will have a corresponding passphrase.
Description
Select the interface (Ethernet, Wireless, All Interfaces) from which
you can manage the AP via telnet. This parameter can also be used to
Disable telnet management.
The default port number for Telnet applications is 23. However, you
can use this field if you want to change the Telnet port for security
reasons (but your Telnet application also must support the new port
number you select). You must reboot the Access Point if you change
the Telnet Port.
Enter the number of seconds the system will wait for a login attempt.
The AP terminates the session when it times out. The range is 1 to 300
seconds; the default is 30 seconds.
Enter the number of seconds the system will wait during a session
while there is no activity. The AP will terminate the session on timeout.
The range is 1 to 36000 seconds; the default is 900 seconds.