Priority Mapping - Avaya AP-7 User Manual

5. Enter the Policy Name.
6. Select the Policy Type:
inlayer2: inbound traffic direction, Layer 2 traffic type
l
inlayer3: inbound traffic direction, Layer 3 traffic type
l
outlayer2: outbound traffic direction, Layer 2 traffic type
l
outlayer3: inbound traffic direction, Layer 3 traffic type
l
spectralink: SpectraLink traffic
l
7. Enter the Priority Mapping Index.
For layer 2 policies, an index from the 802.1p to 802.1d mapping table should be specified.
For layer 3 policies, an index from the 802.1p to IP DSCP mapping table should be
specified. No mapping index is required for SpectraLink.
8. Select whether to Enable QoS Marking.

Priority Mapping

Use this page to configure QoS 802.1p to 802.1d priority mappings (for layer 2 policies) and IP
DSCP to 802.1d priority mappings (for layer 3 policies). The first entry in each table contains the
recommended priority mappings. Custom entries can be added to each table with different
priority mappings.
1. Click Configure > QoS > Priority Mapping. See
Wireless Multimedia Extensions (WME)/Quality of Service (QoS)
Figure 53.
Issue 1 September 2004 149