Table of Contents
Advertisement
ScanTool Instructions
Follow these steps to install ScanTool, initialize the Access Point, and perform initial
configuration:
1. Locate the unit's Ethernet MAC address and write it down for future reference. The MAC
address is printed on the product label. Each unit has a unique MAC address, which is
assigned at the factory.
2. Confirm that the AP is connected to the same LAN subnet as the computer that you will use
to configure the AP.
3. Power up, reboot, or reset the AP.
Result: The unit requests an IP Address from the network DHCP server.
4. Insert the Installation CD into the CD-ROM drive of the computer that you will use to
configure the AP.
Result: The installation program will launch automatically.
5. Follow the on-screen instructions to install the Access Point software and documentation.
Note:
The Avaya Installation program supports the following operating systems:
Note:
- Windows 98SE
- Windows 2000
- Windows NT
- Windows ME
- Windows XP
6. After the software has been installed, double-click the ScanTool icon on the Windows
desktop to launch the program (if the program is not already running).
Result: ScanTool scans the subnet and displays all detected Access Points. The
ScanTool's Scan List screen appears, as shown in the following example.
Note:
If your computer has more than one network adapter installed, you will be
Note:
prompted to select the adapter that you want ScanTool to use before the Scan
List appears. If prompted, select an adapter and click OK. You can change your
adapter setting at any time by clicking the Select Adapter button on the Scan
List screen. Note that the ScanTool Network Adapter Selection screen will not
appear if your computer only has one network adapter installed.
Initialization
Issue 1 September 2004
29
Advertisement
Table of Contents
