Table of Contents
Advertisement
Table 8: Operational Mode Parameters
Parameter
Enable Turbo Mode
Enable 802.11d
ISO/IEC 3166-1
CountryCode
Enable TX Power
Control
Wireless-A: Transmit
Power Level
Description
Dynamic Turbo mode is supported in 802.11a and 802.11g mode.
Dynamic turbo mode supports turbo speeds at twice the standard
802.11a/g data rates, and also dynamically switches between
turbo mode speeds and normal speeds depending on the wireless
client. If turbo mode is enabled, then this is displayed in the Web
interface and the transmit speeds and channels pull-down menus
are updated with the valid values.
When Turbo mode is enabled, only a subset of the wireless
channels on both the 2.4 GHz and 5.0 GHz spectrum can be
used.
!
Important:
Turbo mode can be configured only when Super
Important:
Mode has already been enabled.
Note:
The Super G/A mode and Turbo G mode are
Note:
supported in all regulatory domains. However,
Turbo A mode is not available in the Japan
regulatory domain.
Enables IEEE 802.11d support for additional regulatory domains.
For information on this parameter, see
Additional Regulatory Domains
Select the country (regulatory domain) where the AP is located. For
information on this parameter, see
Additional Regulatory Domains
Enables TX Power Control to control transmit power of
802.11-enabled clients within an IBSS. For information on this
parameter, see
TX Power Control
Select the power level of the interface when IBSS Power Control is
enabled to one of four levels: 100%, 50%, 25%, or 12.5%. For
information on this parameter, see
Interface Configuration
IEEE 802.11D Support for
on page 66.
IEEE 802.11D Support for
on page 66.
on page 66.
TX Power Control
Issue 1 September 2004
on page 66.
2 of 2
65
Advertisement
Table of Contents
