Table of Contents
Advertisement
Figure 41: Rogue Scan Screen
To enable Rogue Scan and define the Scan Interval:
1. Enable the Security Alarm Group. Select the Security Alarm Group link from the Rogue
Scan screen. Configure a Trap Host to receive the list of access points (and clients)
detected during the scan.
2. Click Configure > Alarms > RogueScan.
3. Enable Rogue Scan on the wireless interface by checking Enable Rogue Scan.
Note:
Rogue Scan cannot be enabled on a wireless interface when the Wireless
Note:
Service Status on that interface is shutdown. First, resume service on the
wireless interface.
4. Enter the Scan Mode. Select Background Scanning or Continuous Scanning. In
Continuous Scanning mode the AP stops normal operation and scans continuously on that
interface. In Background Scanning mode, the AP performs background scanning while
doing normal AP operation on that interface.
Alarm Configuration
Issue 1 September 2004
115
Advertisement
Table of Contents
