Wireless Interface Configuration (802.11A/B/G Radio) - Avaya AP-7 User Manual

When an 802.11d-enabled client learns the regulatory domain related information from Beacon
and Probe Response frames, it learns the power level advertised in Beacon and Probe
response frames as the maximum transmit power of the regulatory domain and configures itself
to operate with that power level.
As a result, the transmit power level of the BSS is configured to the power level set in the AP
(assuming that the BSS has only 802.11d enabled clients and an 802.11d enabled AP).
To configure TX power control:
1. Click Configure > Interfaces > Operational Mode.
2. Select Enable Transmit Power Control.
3. Select the transmit power level for interface A from the Wireless-A: Transmit Power Level
drop-down menu.
4. Click OK.
5. Set the transmit power control settings on the clients appropriately.

Wireless Interface Configuration (802.11a/b/g radio)

To configure and view the radio parameters for the Access Point's wireless interface, use the
Wireless subtab. See
view on the Wireless subtab.
Note:
You must reboot the Access Point before any changes to these parameters take
Note:
effect.
Figure 25. Table 9 describes the parameters that you can configure and
Interface Configuration
Issue 1 September 2004 67