Table of Contents
Advertisement
Enable/Disable Closed System
[Device-Name]> set wif <index> closedsys <enable/disable>
Set the Distance Between APs (802.11b Only)
[Device-Name]> set wif <index> distaps <large, medium, small, minicell, microcell>
[Device-Name]> reboot
Note:
The distance between APs should not be approximated. It is calculated by means
Note:
of a manual Site Survey, in which an AP is set up and clients are tested
throughout the area to determine signal strength and coverage, and local limits
such as physical interference are investigated. From these measurements the
appropriate cell size and density is determined, and the optimum distance
between APs is calculated to suit your particular business requirements.
Set the Multicast Rate (802.11b Only)
[Device-Name]> set wif <index> multrate <1,2,5.5,11 (Mbits/sec)>
Note:
The Distance Between APs must be set before the Multicast Rate.
Note:
Note:
There is an inter-dependent relationship between the Distance between APs and
Note:
the Multicast Rate. In general, larger systems operate at lower average transmit
rates.
Table 109: Distance between APs vs. Multicast Rate
Distance between APs
Large
Medium
Small
Minicell
Microcell
802.11b Wireless Interface Commands
Multicast Rate
1 and 2 Mbits/sec
1, 2, and 5.5 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
Issue 1 September 2004
285
Advertisement
Table of Contents
