Avaya AP-7 User Manual page 34

Getting Started
Figure 8: Scan List
7. Locate the MAC address of the AP you want to initialize within the Scan List.
Note:
If your Access Point does not show up in the Scan List, click the Rescan button
Note:
to update the display. If the unit still does not appear in the list, see
Troubleshooting the AP-7
Point, it may take up to five minutes for the unit to appear in the Scan List.
8. Do one of the following:
If the AP has been assigned an IP address by a DHCP server on the network, write down
l
the IP address and click Cancel to close ScanTool. Proceed to Setup Wizard for
information on how to access the HTTP interface using this IP address.
If the AP has not been assigned an IP address (in other words, the unit is using its default
l
IP address), follow these steps to assign it a static IP address that is valid on your
network:
a. Highlight the entry for the AP you want to configure.
b. Click the Change button.
Result: the Change screen appears. See
30 Avaya Wireless AP-7 User Guide
for suggestions. Note that after rebooting an Access
Figure 9.