Table of Contents
Advertisement
Parameter Tables
Objects contain groups that contain both parameters and parameter tables. Use the parameter
tables in the following sections to configure the Access Point. Columns used in the tables
include:
Name - Parameter, Group, or Table Name
•
Type - Data type
•
Values - Value range, and default value, if any
•
Access = access type, R = Read Only (show), RW = Read-Write (can be "set"), W = Write
•
Only
CLI Parameter - Parameter name as used in the Access Point
•
Access Point network objects are associated with Groups. The network objects and their
associated parameters are described in the following sections.
Auto Configuration Commands
The Auto Configuration feature automatically configures an AP by downloading a specific
configuration file from a TFTP server during the boot up process.
Perform the following commands to enable and set up automatic configuration:
Note:
The configuration filename and TFTP server IP address are configured only
Note:
when the AP is configured for Static IP. If the AP is configured for Dynamic IP,
these parameters are not used and obtained from DHCP. The default filename is
config. The default TFTP IP address is 169.254.128.133 for the AP.
Parameter Tables
Issue 1 September 2004
225
Advertisement
Table of Contents
