Bootloader Cli - Avaya AP-7 User Manual

The Command Line Interface
Table 43: CLI Error Messages
Error Message
Invalid Parameter
Name
Invalid Parameter
Value
Invalid Table Index
Invalid Table
Parameter
Invalid Table
Parameter Value
Read Only
Parameter
Incorrect Password
Download
Unsuccessful
Upload
Unsuccessful

Bootloader CLI

Administrators use the CLI to control Access Point operation and monitor network statistics. The
AP supports two types of CLI: the Bootloader CLI and the normal CLI. The Bootloader CLI
provides a limited command set, and is used to perform initial configuration of the AP when the
current AP image is bad or missing. The Bootloader CLI allows you to assign an IP Address and
download a new image. Once the image is downloaded and running, the Access Point uses the
normal CLI. This guide covers the normal CLI unless otherwise specified.
The Bootloader CLI is accessible via the serial interface only if the AP does not contain a
software image or a download image command over TFTP has failed.
The Bootloader CLI provides you with the ability to configure the initial setup parameters as well
as download a software image to the device.
The following functions are supported by the Bootloader CLI:
set command to configure the device's initial parameters
•
show command to view the device's configuration parameters
•
206 Avaya Wireless AP-7 User Guide
Description
An invalid parameter name has been entered at the command prompt.
An invalid parameter value has been entered at the command prompt.
An invalid table index has been entered at the command prompt.
An invalid table parameter has been entered at the command prompt.
An invalid table parameter value has been entered at the command
prompt.
User is attempting to configure a read-only parameter.
An incorrect password has been entered in the CLI login prompt.
The download operation has failed due to incorrect TFTP server IP
Address or file name.
The upload operation has failed due to incorrect TFTP server IP
Address or file name.
2 of 2