Operational Mode - Avaya AP-7 User Manual

Table 110: 802.11b/g Parameters
Name
3
TurboMode
Note 1: For 802.11a APs in Europe, Auto Channel Select is a read-only parameter; it is always
enabled.
Note 2: Wireless Service Status cannot be shutdown on an interface where Rogue Scan is
enabled.
Note 3: Super Mode must be enabled first on the wireless interface before Turbo Mode can be
enabled.
Network Name (SSID)
[Device-Name]> set wif <index 3> netname <Network Name (SSID) for wireless
interface>
[Device-Name]> show wif
For results of the show wif command, see

Operational Mode

[Device-Name]> set wif <index> mode <1,2,3, or 4. See
Table 110>
TX Power Control
[Device-Name]> set wif <interface number> currenttxpowerlevel <value>
Allowed values are: 1 (100%), 2 (50%), 3 (25%), 4 (12.5%)
For more information on the TX Power Control feature, see
page 276.
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]> set wif <index> autochannel <enable/disable>
[Device-Name]> reboot 0
Enable/Disable Closed System
[Device-Name]> set wif <index> closedsys <enable/disable>
Type Values
Integer enable
disable (default)
802.11b/g Wireless Interface Commands
Access
RW
Figure 93.
Wireless Operational Mode
TX Power Control Commands
CLI Parameter
turbomode
Issue 1 September 2004
4 of 4
in
on
289