Avaya AP-7 User Manual page 283

Table 107: 802.11a Parameters
Name
Wireless
Operational Mode
Operating
Frequency Channel
Multicast Rate
Supported Data
Rates
Transmit Rate
Physical Layer
Type
SuperMode
3
TurboMode
Note 1: For 802.11a APs in Europe, Auto Channel Select is a read-only parameter; it is always enabled.
Note 2: Wireless Service Status cannot be shutdown on an interface where Rogue Scan is enabled.
Note 3: Super Mode must be enabled first on the wireless interface before Turbo Mode can be enabled.
Type Values
Integer 1=802.11b only
2=802.11g only
3=802.11bg
4=802.11a only
Integer Varies by regulatory
domain and country. See
802.11a Channel
Frequencies
Integer Mbits/sec
6
9
12
18
24
36
48
54
Octet String See Transmit
Integer32 0 - Auto Fallback (default)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
Integer ofdm (orthogonal frequency
division multiplexing) for
802.11a
Integer enable
disable (default)
Integer enable
disable (default)
802.11a Wireless Interface Commands
Access
RW
RW
on page 308
RW
Rate, below R
RW
R
RW
RW
Issue 1 September 2004
CLI Parameter
mode
channel
multrate
suppdatarates
txrate
phytype
supermode
turbomode
2 of 2
279