Table of Contents
Advertisement
Performing Advanced Configuration
When an AP is configured for dynamic IP, the Configuration filename and the TFTP server IP
address are contained in the DHCP response when the AP receives its IP address dynamically
from the DHCP server. When configured for static IP, these parameters are instead configured
in the AP interface.
After setting up automatic configuration you must reboot the AP. When the AP reboots it
receives the new configuration information and must reboot one additional time. If Syslog is
configured, a Syslog message will appear indicating the success or failure of the Automatic
Configuration.
Auto Configuration and the CLI Batch File
The Auto Configuration feature allows download of the LTV format configuration file or the CLI
Batch file. The AP detects whether the file uploaded is LTV format or a CLI Batch file. If the AP
detects a CLI Batch file (a file with extension .cli), the AP executes the file immediately.
The AP will reboot after executing the CLI Batch file. Auto Configuration will not result in
repeated reboots if the CLI Batch file contains rebootable parameters.
For more information, see
Set up Automatic Configuration for Static IP
Perform the following procedure to enable and set up Automatic Configuration when you have a
static IP address for the TFTP server.
1. Click Configure > Management > AutoConfig. The Automatic Configuration Screen
appears. See
2. Check Enable Auto Configuration.
3. Enter the Configuration Filename.
4. Enter the IP address of the TFTP server in the TFTP Server Address field.
The default filename is config. The default TFTP IP address is "169.254.128.133" for AP-7.
5. Click OK to save the changes.
6. Reboot the AP. When the AP reboots it receives the new configuration information and
must reboot one additional time. If a Syslog server was configured, the following messages
can be observed on the Syslog server:
AutoConfig for Static IP
l
TFTP server address and configuration filename
l
AutoConfg Successful
l
92 Avaya Wireless AP-7 User Guide
Using CLI Batch Files
Figure
34.
on page 297.
Advertisement
Table of Contents
