Table of Contents
Advertisement
8. Enter the MAC Address that you wrote down in Step 2 in one of the Partner MAC Address
field of the Wireless Distribution Setup window.
9. Set the Status of the device to Enable.
10. Click OK
.
11. Reboot the AP.
Ethernet Interface Configuration
Select the desired speed and transmission mode from the drop-down menu. Half-duplex means
that only one side can transmit at a time and full-duplex allows both sides to transmit. When set
to auto-duplex, the AP negotiates with its switch or hub to automatically select the highest
throughput option supported by both sides.
Figure 31: Ethernet Sub-tab
For best results, Avaya recommends that you configure the Ethernet setting to match the speed
and transmission mode of the device the Access Point is connected to (such as a hub or
switch). If in doubt, leave this setting at its default, auto-speed-auto-duplex. Choose between:
10 Mbit/s - half duplex or full duplex
•
100 Mbit/s - half duplex or full duplex
•
auto speed - auto duplex
•
Interface Configuration
Issue 1 September 2004
79
Advertisement
Table of Contents
