Table of Contents
Advertisement
Table 2: Wireless Interface Settings
Option
Set Encryption Key 1
Multicast Rate
Note:
Additional advanced settings are available in the Wireless Interface Configuration
Note:
screen. See
features,
VLAN Overview
VLAN Configuration
10. Review the configuration summary. If you want to make any additional changes, use the
navigation panel on the left-hand side of the screen to return to an earlier screen. After
making a change, click Save & Next to save the change and proceed to the next screen.
11. When finished, click Reboot on the Summary screen to restart the AP and apply your
changes.
Description
If you enabled Encryption, configure an Encryption Key.
This key is used to encrypt and decrypt data between the
AP and its wireless clients. Enter the number of
characters that correspond to the desired key size, as
described below:
Enter 10 hexadecimal characters (0-9 and A-F) or 5
l
ASCII characters (see
page 299 to use 64-bit encryption.s
Enter 26 hexadecimal characters or 13 ASCII
l
characters to use 128-bit encryption.
Enter 32 hexadecimal characters or 16 ASCII
l
characters to use 152-bit encryption.
Sets the rate at which Multicast messages are sent.
Possible Multicast Rates are:
1 and 2 Mbits/sec
l
1, 2, and 5.5 Mbits/sec
l
1, 2, 5.5 and 11 Mbits/sec
l
1, 2, 5.5 and 11 Mbits/sec
l
1, 2, 5.5 and 11 Mbits/sec
l
See
Multicast Rate
Security Configuration
on page 135 for a description of VLAN capabilities, and
on page 139 for the detailed configuration procedure.
ASCII Character Chart
on page 74 for more information.
on page 129 for a description of security
Issue 1 September 2004
Initialization
on
3 of 3
37
Advertisement
Table of Contents
