Table of Contents
Advertisement
Figure 34: Automatic Configuration Screen
Set up Automatic Configuration for Dynamic IP
Perform the following procedure to enable and set up Automatic Configuration when you have a
dynamic IP address for the TFTP server via DHCP.
The Configuration filename and the TFTP server IP address are contained in the DHCP
response when the AP receives its IP address dynamically from the DHCP server. A Syslog
server address is also contained in the DHCP response, allowing the AP to send Auto
Configuration success and failure messages to a Syslog server.
Note:
The configuration filename and TFTP server IP address are configured only
Note:
when the AP is configured for Static IP. If the AP is configured for Dynamic IP
these parameters are not used and obtained from DHCP.
1. Click Configure > Management > AutoConfig. The Automatic Configuration Screen
appears. See
2. Check Enable Auto Configuration.
When the AP is Configured with Dynamic IP, the DHCP server should be configured with the
TFTP Server IP address ("Boot Server Host Name", option 66) and Configuration file ("Bootfile
name", option 67) as follows:
3. Select DHCP Server > DHCP Option > Scope. The DHCP Options: Scope Screen
appears. See
Figure
34.
Figure
35.
Management Configuration
Issue 1 September 2004
93
Advertisement
Table of Contents
