Table of Contents
Advertisement
Performing Advanced Configuration
5. If the Scan Mode is Background Scanning, then enter the Scan Interval.
The Scan Interval specifies the time period in minutes between scans in Background
Scanning mode and can be set to any value between 1 and 1440 minutes.
6. Configure the Scan Result Table Ageing Time. The AP ages out older entries in the
Rogue Scan result table if a detected station is inactive for more than this time. The valid
range is from 60-7200 minutes, the default is 60 minutes.
7. Configure the Scan Results Trap Notification Mode to control the notification behavior
when APs or stations are detected in a scan:
No Notification
l
Notify AP
l
Notify Client
l
Notify All (Notify both AP and Client detection)
l
8. Configure the Scan Results Trap Report Style to control the way detected stations are
reported in the notification:
Report all detected stations since last scan (default)
l
Report all detected stations since start of scan
l
9. Click OK.
The results of the Rogue Scan be viewed in the Status page in the HTTP interface.
Bridge Configuration
The AP is a bridge between your wired and wireless networking devices. As a bridge, the
functions performed by the AP include:
MAC address learning
•
Forward and filtering decision making
•
Spanning Tree protocol used for loop avoidance
•
Once the AP is connected to your network, it learns which devices are connected to it and
records their MAC addresses in the Learn Table. The table can hold up to 10,000 entries. To
view the Learn Table, click on the Monitor button in the web interface and select the Learn
Table tab. See
116 Avaya Wireless AP-7 User Guide
Learn Table
on page 163.
Advertisement
Table of Contents
