Table of Contents
Advertisement
5. Under File > Properties > Settings > ASCII Setup, enable the Send line ends with line
feeds option.
Result: HyperTerminal sends a line return at the end of each line of code.
6. Press the RESET button on the AP.
Result: The terminal display shows Power On Self Tests (POST) activity. After
approximately 30 seconds, a message indicates: Sending Traps to SNMP manager
periodically. After this message appears, press the ENTER key repeatedly until the
following prompt appears:
[Device name]>
7. Enter only the following statements:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr <Access Point IP Address>
[Device name]> set ipsubmask <IP Mask>
[Device name]> set tftpipaddr <TFTP Server IP Address>
[Device name]> set tftpfilename <AP Image File Name, including file extension>
[Device name]> set ipgw <Gateway IP Address>
[Device name]> show ip (to confirm your new settings)
[Device name]> show tftp (to confirm your new settings)
[Device name]> reboot 0
Example:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr 10.0.0.12
[Device name]> set ipsubmask 255.255.255.0
[Device name]> set tftpipaddr 10.0.0.20
[Device name]> set tftpfilename MyImage.bin
[Device name]> set ipgw 10.0.0.30
[Device name]> show ip
[Device name]> show tftp
[Device name]> reboot 0
Result: The AP will reboot and then download the image file. You should see downloading
activity begin after a few seconds within the TFTP server's status screen.
8. When the download process is complete, configure the AP as described in
2: Getting Started
and
Chapter 4: Performing Advanced
Recovery Procedures
Chapter
Configuration.
Issue 1 September 2004
197
Advertisement
Table of Contents
