Table of Contents
Advertisement
Table 116: DSCP to 802.1D Mapping
Name
IP DSCP Upper Limit
Table Row Status
QoS EDCA Parameters
The following commands configure the client (STA) and AP Enhanced Distributed Channel
Access (EDCA) parameters. You can modify the EDCA values for both Wireless A and Wireless
B (when applicable).
The EDCA parameter set provides information needed by the client stations for proper QoS
operation during the wireless contention period. These parameters are used by the QoS
enabled AP to establish policy, to change policies when accepting new stations or new traffic, or
to adapt to changes in the offered load. The EDCA parameters assign priorities to traffic types
where higher priority packets gain access to the wireless medium more frequently than lower
priority packets.
Note:
Avaya has defined default recommended values for EDCA parameters and
Note:
recommends that you not modify EDCA parameters unless strictly necessary.
.
Table 117: EDCA Parameters
Name
EDCA Table
Table Index
CWmin
CWmax
AIFSN
Tx OP Limit
MSDU Lifetime
Type
Integer
Row Status
Type
Values
Table
N/A
Integer
1 - 4
Integer
0 - 255
Integer
0 - 65535
Integer
2 - 15
Integer
0 - 65535
Integer
0 - 500
Values
Access
1 - 63
RW
enable
RW
disable
delete
Access
N/A
R
RW
RW
RW
RW
RW
Issue 1 September 2004
WME/QoS Commands
CLI Parameter
dscpupper
status
2 of 2
CLI Parameter
qosedcatbl
index
cwmin
cwmax
aifsn
txoplimit
msdulifetime
1 of 2
295
Advertisement
Table of Contents
