Table of Contents
Advertisement
The Command Line Interface
Syntax Examples
[Device-Name]> set dhcpstatus disable
[Device-Name]> set dhcpippooltbl 0 startipaddr <start ip address> endipaddr <end ip
address>
[Device-Name]> set dhcpgw <gateway ip address>
[Device-Name]> set dhcppridnsipaddr <primary dns ip address>
[Device-Name]> set dhcpsecdnsipaddr <secondary dns ip address>
[Device-Name]> set dhcpstatus enable
[Device-Name]> reboot 0
Enable or Disable DHCP Relay
Use the following command to enable DHCP Relay Agent status:
Note:
You must have at least one entry in the DHCP Relay Server Table before you
Note:
can set the DHCP Relay Status to Enable.
[Device-Name]> set dhcprelaystatus enable
Configure DHCP Relay Servers
Use the following command to configure and enable a DHCP Relay Server. The AP allows the
configuration of a maximum of 10 server settings in the DHCP Relay Agents server table.
[Device-Name]> set dhcprlyindex 1 dhcprlyipaddr <ip address> dhcprlycmt
<comment> dhcprlystatus 1 (1 to enable, 2 to disable, 3 to delete, 4 to create)
230 Avaya Wireless AP-7 User Guide
Advertisement
Table of Contents
