Avaya AP-7 User Manual page 241

Configure TCP/UDP Port Filters
The following parameters are used to configure TCP/UDP Port filters.
Table 70: TCP/UDP Port Filtering Table
Name
Port Filtering
Table
Table Index
Port Type
Port Number
Protocol Name
Interface
Bitmask
Status (optional)
Type Values
Table N/A
N/A User Defined
(there are also 4
pre-defined indices, see
Port Number in this table
for more information)
Octet String tcp
udp
tcp/udp
Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137,
Index 2: NetBios
Datagram Service – 138,
Index 3: NetBios Session
Service – 139,
Index 4: SNMP Service –
161)
DisplayString User Defined
(there are also 4
pre-defined protocols, see
Port Number above)
Integer32 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless
5 or 7 - all interfaces
(default is 7)
Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete
Filtering Commands
Access CLI Parameter
R portflttbl
R index
RW porttype
RW portnum
RW protoname
RW ifbitmask
RW status
Issue 1 September 2004 237