Front View - Lightware HDMI-TPS-RX110AY Series User Manual


  
3. Product Overview
3.1. Front View
1 2
Relay 4-polePhoenixconnector forrelayports.Pinassignmentcanbefoundinthe
1
Relay Connector
2 IR IN and OUT 3-pole TRS connector, also known as 3.5 mm (1/8") jack plug for optional IR
receiver (IR IN) and transmitter (IR OUT). Pin assignments can be found in the
IR Connector
USB USBinterfaceforLDCconnectiontocontrolthereceiver.
3
4 RS-232 3-pole Phoenix connector for controlling the device with LDC or third-party
control systems. Pin assignment can be found in the
Ethernet LockingRJ45connectorforcontrollingthedevicewithLDCorthird-partycontrol
5
systemsandLDUforfirmwareupgrade.
6 Status LEDs TheLEDsgiveimmediatefeedbackaboutcurrentstateofthedevice.Seebelow
the details.
Reset button Pressing reset button reboots the extender.
7
8 Function button Special functions are available with this button (switch to bootload mode, enable
DHCP, restore factory default settings). For the details about special functions see
the Front Panel - Special Functions

INFO: TheilluminationofthestatusLEDscanbeswitchedoff(darkmode)intheLDCsoftware(seethe
details in the Front Panelsection)andusingLW3protocolcommand(seethedetailsintheDark Mode
section).
3 4 5 6
section.
section.
RS-232 Connector
section.
Appliedfirmwarepackage:v1.4.0 | LDCsoftware:v2.4.0b3
HDMI-TPS-RX110AY series – User's Manual
Status LEDs
LIVE
7 8
RS-232
AUDIO OUT
TPS LINK
section.
OFF: The device is not powered.
BLINKING: (slow;1sec):Deviceispoweredandoperational.
(fast;0,5sec):Deviceisinbootloadmode.
ON: The device is powered but not operational.
OFF: RS-232 ports (local and link) in Passthrough mode.
BLINKING: Command Injection mode is active.
ON: RS-232 ports (local and link) are in Control mode.
OFF: Embedded audio is not present or analog output is muted.
BLINKING: Embedded audio format is not supported for audio de-embedding.
ON: Embedded audio is present and de-embedded.
OFF: No TPS link between transmitter and receiver.
BLINKING: Device is in low power mode or in Ethernet fallback mode.
ON: TPSlinkisestablished,HDBaseTorLongReachmodeisactive.
17