Preventive Maintenance; Weekly - Kodak X-Omat 460 RA Operator's Manual

Weekly

40

Preventive Maintenance

For periodic (or monthly) maintenance, see the Service Manual for the processor.
[1] Move the main circuit breaker, CB1, to the ''O'' position.
[2] Move the wall power switch to the ''OFF'' position.
[3] Turn off the water supply.
[4] Disconnect the water hoses from the crossovers.
To prevent fixer/developer contamination when you remove the fixer
rack, place the splash guard between the developer and fixer tanks.
Use the rack drip tray when you remove or install any of the racks.
SPLASH
GUARD
[5] Remove the evaporation covers, all crossover assemblies, and all racks.
[6] Carefully, clean the film accumulator cover with a damp cloth.
[7] Rinse and wipe the removed parts with a damp cloth.
[8] Clean the detector crossover with a soft fiber brush and warm water. Allow it to
air dry before processing film.
[9] Check that the rack rollers turn and rotate freely.
[10] Remove the developer heat exchanger cover from the bottom of the developer
tank.
[11] Wash the developer heat exchanger cover with developer system cleaner that
has been mixed correctly.
IMPORTANT
RACK
DRIP
TRAY
Figure 12 Splash Guard and Drip Tray
H108_0035ACA
H108_0035AA
636736